30
Basic Programming Setup
9-E.
Read the Velocity cutoff warning on the screen. Press any key to continue.
9-F.
Enter the Velocity Cutoff, using the numeric keypad. Press
ACCEPT
to continue.
9-G.
Enter the Velocity Default using the numeric keypad. Press
ACCEPT
to end the
basic programming setup.
Note:
Velocity Cutoffs are used at sites where low velocities and frequent low particulate
concentrations occur, if velocity cannot be measured.
Example 1:
Velocity Cutoff = 0.20 fps, Velocity Default = 0 fps
If the velocity falls below 0.20 fps, the meter will store a value of 0 fps until the velocity
increases above 0.20 fps.
Example 2:
Velocity Cutoff = 0.20 fps, Velocity Default = 0.20 fps
If the velocity falls below 0.20 fps, the meter will store a value of 0.20 fps until the
velocity increases above 0.20 fps.
5.3 Starting and Stopping Programs
Note:
When selecting START FROM BEGINNING, all logged data will be cleared from memory.
When saving the logged data, make sure the data is downloaded to a DTU or personal computer. If
a program is complete, the logger can only be restarted from the beginning (and will clear all logged
data).
When basic programming setup is completed, “run” (or execute) the program selections.
Press the
RUN/STOP
key to run a program, resume a currently halted program, or stop a
program.
If a program has been halted (and no changes to the program settings were made while it
was stopped), press the
RUN
key. Select either resume to previously running program
(and retain all logged data) or Start From Beginning (and clear all logged data)
Содержание Sigma 950
