54
Optional Device Installation
7.5 Conductivity Probe
7.5.1 Conductivity Probe Connection
The pre-amp (P/N 3369 or 3212) is required. Plug the probe into the pre-amp and plug
the pre-amp into the 950 Flow Meter.
7.5.2 Conductivity Probe Programming
1.
From the Main Menu, select
OPTIONS>ADVANCED OPTIONS>DATALOG.
2.
Highlight Select Inputs using the
UP
and
DOWN
soft keys and then press
SELECT
.
3.
Highlight Conductivity (COND.) using the
UP
and
DOWN
soft keys, then press
SELECT
.
4.
Press
CHANGE CHOICE
to cycle between Logged and Not Logged, then press
ACCEPT
.
5.
Enter a logging interval using the numeric keypad, then press
ACCEPT
. Valid logging
intervals are shown on the status bar along the bottom edge of the display.
6.
Press
CHANGE CHOICE
to select the appropriate units (mS, uS). Press
ACCEPT
to
continue.
7.
Select another channel to configure or press
RETURN
to back up one step. Press the
MAIN MENU
function key to return to the Main Menu.
7.5.3 Conductivity Temperature Programming
Note:
Conductivity measurements are only temperature compensated if the conductivity
temperature is enabled in the datalog.
1.
From the Main Menu, select
OPTIONS>ADVANCED OPTIONS>DATALOG.
2.
Highlight Select Inputs using the
UP
and
DOWN
soft keys and then press
SELECT
.
3.
Highlight Conductivity Temperature (COND. TEMP.) using the
UP
and
DOWN
soft
keys, then press
SELECT
.
4.
Press
CHANGE CHOICE
to cycle between Logged and Not Logged, then press
ACCEPT
.
5.
Enter a logging interval using the numeric keypad, then press
ACCEPT
. Valid logging
intervals are shown on the status bar along the bottom edge of the display.
Table 20 Conductivity Pin Assignments
Pin
Signal Description
Wire Color
A
+12 V dc
white
B
signal ground
blue
C
input 1 (4–20 mA dc)
yellow
D
input 2 (4–20 mA dc
black
E
input 3 (4–20 mA dc)
red
F
dissolved oxygen (+)
green
G
dissolved oxygen temp. probe(+)
gray
H
conductivity (+)
brown
J
conductivity temp. probe
purple
K
not used
orange
Содержание Sigma 950
