H3C SOHO IE4300, Справочник по командам

Страница: 524 / 3296

2
loopback-detection action
Use
loopback-detection action
to set the loop protection action on a per-port basis.
Use
undo loopback-detection action
to restore the default.
Syntax
In Layer 2 Ethernet interface view:
loopback-detection action { block | no-learning | shutdown }
undo loopback-detection action
In Layer 2 aggregate interface view:
loopback-detection action shutdown
undo loopback-detection action
Default
When the device detects a loop on a port, it generates a log but performs no action on the port.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
block
: Enables the block mode. If a loop is detected, the device performs the following operations:
•
Generates a log.
•
Disables MAC address learning.
•
Blocks the port.
Layer 2 aggregate interfaces do not support this keyword.
no-learning
: Enables the no-learning mode. If a loop is detected, the device generates a log and
disables MAC address learning on the port. Layer 2 aggregate interfaces do not support this
keyword.
shutdown
: Enables the shutdown mode. If a loop is detected, the device generates a log and shuts
down the port. The device automatically sets the port to the forwarding state after the time interval
set by using the
shutdown-interval
command (see Fundamentals Command Reference ).
Usage guidelines
To set the loop protection action globally, use the
loopback-detection global action
command.
The global action applies to all ports. The per-port action applies to the individual ports. The per-port
action takes precedence over the global action.
Example
# Set the loop protection action to shutdown on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[System-GigabitEthernet1/0/1] loopback-detection action shutdown