H3C SOHO IE4300, Справочник по командам

Страница: 462 / 3296

2
port-isolate enable
Use
port-isolate enable
to assign a port to an isolation group.
Use
undo port-isolate enable
to remove a port from an isolation group.
Syntax
port-isolate enable group group-id
undo port-isolate enable
Default
The port is not assigned to an isolation group.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
group group-id
: Specifies an isolation group by its ID. The value range is 1 to 8.
Usage guidelines
The configuration in Layer 2 Ethernet interface view applies only to the interface.
The configuration in Layer 2 aggregate interface view applies to the Layer 2 aggregate interface and
its aggregation member ports. If the device fails to apply the configuration to the aggregate interface,
it does not assign any aggregation member port to the isolation group. If the failure occurs on an
aggregation member port, the device skips the port and continues to assign other aggregation
member ports to the isolation group.
To assign ports to an isolation group, make sure the isolation group already exists.
One port can be assigned to only one isolation group.
Examples
# Assign GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 to isolation group 1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port-isolate enable group 1
[Sysname-GigabitEthernet1/0/1] quit
[Sysname] interface gigabitethernet 1/0/2
[Sysname-GigabitEthernet1/0/2] port-isolate enable group 1
Related commands
display port-isolate group
port-isolate group
Use
port-isolate group
to create an isolation group.
Use
undo port-isolate group
to delete isolation groups.
Syntax
port-isolate group group-id