GEZE TSA 160 NT F, Схема подключения

Страница: 26 / 64

TSA 160 NT
26
Configurable inputs
11.10 Closing position monitoring, closing position blanking SIS, Push And Go
A closing position limit switch has to be used for closing position monitoring, for blanking the safety sensor close (SIS),
for the Push And Go function as well as for the opening delay function. The closing position limit switch can be a
supplementary cam switch that is mounted in the drive or a Reed switch that is mounted at the door.
à For notes and settings for the Push And Go function see chapter 10, “Push And Go”.
à When the door leaf is closed, the contact is closed, 24 V is applied to the input.
à
Additional cam-operated switch, mat. no. 71154
or
1 Additional cam-operated switch closing position
Set the parameters (closing position monitoring or closing position blanking SIS)
à
For 1-leaf drive:
à
DPS: Set
e1
or
e2
to
0 6
(closing position GF NO).
à ST220: Set “Signals”, “Input signals”, “PE1” or “PE2” to “Closing position GF NO”.
à S1, S2: Set parameter 17 or 18 to value 06 (closing position GF NO).
à
For 2-leaf drive
à
Connect GF closing position limit switch to PE1 or PE2 of the active leaf control.
à
Connect SF closing position limit switch to PE1 or PE2 of the passive leaf control.
Parameter setting at GF control and SF control
à DPS: Set
e1
or
e2
to
0 6
(closing position GF NO).
à
ST220: Set “Signals”, “Input signals”, “PE1” or “PE2” to “Closing position GF NO”.
à
S1, S2: Set parameter 17 or 18 to value 06 (closing position GF NO).