Manualedelleistruzioni per l’uso
Document code
Pag.
di
Rev.
SAVE DATA
PRINT DATA
03-09-12_UIMG2 Manual ENG
12
18
00
23/07/13
23/07/13
7.7. TROUBLESHOOTING/FAILURES
If any of the moving parts become jammed, in order to release them in conditions of safety the
machine
operator must first stop the machine
(by pressing one of the emergency stop buttons if necessary)
and then - if he was not authorized to perform this task -
inform the persons in charge of
maintenance.
The following section describes operations for
troubleshooting and releasing jammed moving parts
,
that
can be performed by maintenance technicians
Before performing any work or inspection:
1. Before restarting the machine, make sure no personnel are still performing cleaning and/or
maintenance operations on it;
2. For mechanical repairs, always seek the assistance of the authorized service center
3. Always consult the piece manufacturer, as specified in of this manual;
4. Do not zero-set or reset the safety devices automatically by means of an external sequence without
first checking and identifying the cause of the stoppage.
All information devices (visual, audible)
aimed at avoiding potential ergonomic hazards are shown in,
along with the relative explanations and the type of information to be passed on to the operator(s).
Depending on the type of information, action must be taken to eliminate the cause that generated the
visual/audible warning signal.
The type and method of intervention
depend exclusively on the information transmitted
. For the
correct identification and interpretation, refer to the etched wording or the symbol above the information
device, and the indications given in the electrical diagram supplied with the machine.
Before resuming normal productive functioning
, the maintenance service must check the good
condition and operation of the mechanical and electrical and must always consult the machine
manufacturer.
The machine is built using the most advanced technology, and all components are carefully selected on
the basis of their quality.
Despite this, during normal use of the machine various
problems may occur that are anyway easily
rectified
by following the procedures given below.
Instructions concerning replacement are not given in this manual
, and must therefore be explicitly
requested from the machine manufacturer, who reserves the
responsibility for any replacement
interventions.
Always power off and unplug the power cord form the grounded AC outlet prior to performing
any maintenance intervention.
