Instruction Manual Genny 2.0
Urban(English)
Document code
Pag.
of
Rev.
SAVE DATA
PRINT DATA
03-09-12_UIMG2 Manual ENG
28
46
01
23/07/13
23/07/13
4.3. GENERAL STANDARDS FOR PROTECTION OF MACHINES
TEMPORARY REMOVAL OF PROTECTIONS AND SAFETY DEVICES
The protections and safety devices of the machines should not be removed except for professional needs.
If they are to be removed
measures need to be immediately taken to highlight and reduce to a minimum the
possible danger that comes with it.
As soon as the reasons that necessitated their temporary removal exist no longer, the protectionor safety device must be
put into place again.
NO CLEANING, OILING OR GREASING OF MOVING PARTS
It is forbidden to clean, oil or grease manually the organs and moving parts of the machine, unless particular technical
reasons require it, in which case it must be made use of the appropriate means to avoid danger. Workers must be made
aware by clearly visible notices.
PROHIBITION OF REPAIRS OR ADJUSTMENT ON MOVING ORGANS
It is forbidden to perform any repair or adjustment on moving organs.
If you need to perform them in motion, you should use appropriate precautions to ensure the safety of the worker. Workers
must be made aware by clearly visible notices.
BLOCK OF THE STOP POSITION OF THE MACHINE
The machines involved in loading, adjustment, replacement of parts, cleaning, repair and maintenance, that require that
the employee is introduced in them, leaning with parts of the body in or between the organs that can get in motion, must
be equipped with devices that assure the stop position of the machine and its organs during the execution of such
operations.
They have to have taken the necessary measures and precautions to ensure that the machine or its parts are not put in
motion by others.
4.4. MOVING STRUCTURES
Before moving structures always make sure that the area of movement is not occupied by personnel or by objects that could
represent danger.
If the lighting and / or visibility is poor do not move any structure until a manager has established that there is the necessary
freedom of movement within the work area; do not assume that the work area is free, but always visually make sure.
Electrically and mechanically lock all moving parts of a structure or equipment to be transported.
4.5. LIFTING MEANS
When using a lifting device for handling a machine, make sure that the pins for fastening and lifting are put in place correctly.
Take the necessary precautions to prevent dangerous overloads due to acceleration, deceleration or impact forces.
Before lifting a load to make sure it is properly fastened and properly balanced in the lifting device.
DO NOT LIFT LOADS OVER PEOPLE;
IN THESE CASES REDUCE THE LOAD OR FREE THE MOVING AREA
FROM PEOPLE.
Make sure that the slings, used for lifting, are in good condition and suitable for the type of work to be done.
Make sure that the workload of safety of the crane is greater than the weight to be lifted.
