User instruction Manual
Document code
Pag.
di
Rev.
SAVE DATA
PRINT DATA
03-09-12_UIMG2 Manual ENG
12
13
00
23/07/13
23/07/13
5.5.7. RECALIBRATING THE DISPLAY OF THE INFOKEY CONTROLLER
The machine indicates the Battery charge level in the InfoKey Controller
The display may be inaccurate after long periods of storage, or during initial use. To recalibrate the display:
1.Fully charge the Batteries for 12 hours.
2.Discharge the Batteries until the bottom bar in the Display is blinking (approximately 10 percent Battery charge
remaining).
The InfoKey Controller will display the following:
Leave your machine in a safe; secure location, powered on, until the Battery charge is fully depleted, and
your machine powers down.
Fully recharge the Batteries for a minimum of 12 hours, after which the Battery Charge Level Display will
be recalibrated.
Depleting your Genny 2.0 Batteries from the bottom bar to empty could take several hours, depending
on Battery condition and the amount of charge remaining.
To avoid injury, damage, and to deter theft, be sure your machine discharges in a safe, secure location,
powered on in Riderless Balance Mode.
