14-14
GTN 625/635/650 Pilot’s Guide
190-01004-03 Rev. P
Utilities
- If a flight plan other than the active flight plan is selected it shows the
ETA by adding to the departure time all of the ETEs of the legs up to
and including the selected leg. If the entire flight plan is selected, then
the ETA is calculated as if the last leg of the flight plan was selected.
- If the active flight plan is selected the ETA reflects the current position
of the aircraft and the current leg being flown. The ETA is calculated
by adding to the current time the ETEs of the current leg up to and
including the selected leg. If the entire flight plan is selected, then
the ETA is calculated as if the last leg of the flight plan was selected.
• En Route safe altitude (ESA) - The ESA is shown as nnnnnFT
• Destination sunrise and sunset times - These times are shown as
hours:minutes and are the local time at the destination.
NOTE:
The capability of using Sensor Data for the trip planning functions
is available in software versions 2.00, 4.10, and later.
14.4.1 Point-To-Point Mode
The Trip Planning Point-to-Point mode shows trip calculations between two
selected points: either two waypoints from the database or from your present
position to a selected waypoint.
1. While viewing the Utilities page, touch the
Trip Planning
key.
2. Touch the
Mode
key to toggle to Point-to-Point.
Touch to Select
P-to-P or Flight
Plan Mode
Touch to Use
Present Position
as Departure
Point
Touch to Select
Departure Time
Touch to Select
Departure Date
Touch to Select
Departure Waypoint
Touch to Select
Arrival Waypoint
Touch to Toggle
Between Statistics
and Data Input
Touch to Toggle
Sensor Data Use
Figure 14-15 Utility Trip Planning Page To Edit Input Data (Point-To-Point Mode)
-Sensor Data Used
Содержание GTN 625
Страница 608: ...This page intentionally left blank ...
Страница 609: ......
Страница 610: ...190 01004 03 Rev P ...
