Future Design MCTB 4.3, Руководство пользователя

Страница: 211 / 240

MCTB
211
*B4
Parameter
Value
Description
Bit0 Alarm 1 Active
Bit1 Alarm 2 Active
Bit2 Alarm 3 Active
Bit3 Alarm 4 Active
Bit4 Alarm 5 Active
Bit5 Alarm 6 Active
Bit6 Alarm 7 Active
Bit7 Alarm 8 Active
Bit8 Alarm 9 Active
Bit9 Alarm 10 Active
Bit10 Alarm 11 Active
Bit11 Alarm 12 Active
Bit12 Alarm 13 Active
Bit13 Alarm 14 Active
Bit14 Alarm 15 Active
Bit15 Alarm 16 Active
Parameter
Value
Description
Bit0 Alarm 17 Active
Bit1 Alarm 18 Active
Bit2 Alarm 19 Active
Bit3
– Bit15
Not Assigned
*B5
Parameter
Value
Description
Bit0 Loop 1 Manual Mode
Bit1 Loop 2 Manual Mode
Bit2 Loop 3 Manual Mode
Bit3
– Bit15
Not Assigned
*B6
Parameter
Value
Description
Bit0 Loop 1 in Auto Tune
Bit1 Loop 2 in Auto Tune
Bit2 Loop 3 in Auto Tune
Bit3
– Bit15
Not Assigned
Note: Auto tune may not be available depending upon the loop
configuration. If auto tune operation is not available, the bit for the loop
will automatically turn off after being set.
When auto tune completes normally, the bit for the loop will automatically
turn off indicating that tune is complete. To terminate an auto tune in
progress, turn off the bit for the desired loop.
Note: When loop is in manual mode, the loop percentage of output can
be set by writing to the corresponding loop percent output register.
Note: Alarms 1 through 16 are indicated in register 5. The number of
alarms available in the system is dependent upon the configuration.
Note: Alarms 17 through 19 are indicated in register 6. The register will
be used to indicate alarm active status only when more than 16 alarms
are configured.