Furuno FV-110, Руководство оператора

Страница: 179 / 240

D-1
Appendix D
Command line interface
D
D.1 Introduction
After you have done the initial configuration and connected the FV-110 to your network,
you can use Telnet to configure the FV-110. You can also setup VSAT modem
parameters.
After successful login you can read and change settings. Use the command
config
activate
to activate the new settings in the ACU.
You will need to refresh the browser window before the changed settings become visible.
D.1.1 Telnet connection
You can access the command line interface via Telnet.
User name and password
Access to the FV-110 system is protected by a user name and password. This is the same
user name and password that is used in the web interface under
ADMINISTRATION .
Telnet
The interface is on the standard Telnet port 23 or SSH port 22. Use any LAN port and
corresponding IP address of the ACU (except LAN 2 on GX/Ka ACU). To start telnet
session do as follows:
1. Open a Telnet client of your choice.
2. At the prompt, enter the IP address of the ACU, user name (admin) and password
(1234).
Figure D-1: How to use the command line interface (example for telnet)
Note
Every change is performed on the active satellite profile or
the active VSAT modem profile.
Parameter identifiers are case sensitive.
Write new settings to
FV-110
Read or change settings
Connect to FV-110
using IP address