Furuno FV-110, Руководство оператора

Страница: 208 / 240

List of ADU events
G-4
0A028-0 Antenna ERROR Demodulator load The second receiver demodulator cannot be
initialised and loaded correctly.
0A029-0 Antenna ERROR XIM PLL lock The PLL on the VIM/TIM does not lock.
0A02B-0 Antenna ERROR ABS software
version The ABS software version in the antenna is too
old to match the hardware requirements. Upgrade
the software.
0A034-0 Antenna
WARNING
ACU
communication The communication link between ACU and
antenna is down.
0A035-0 Antenna
WARNING
ISM data valid Sensor measurements from the ISM are invalid.
This indicates a malfunctioning ISM.
0A036-0 Antenna
WARNING
ISM data range Sensor measurements from the ISM are out of
range.
0A037-0 Antenna
WARNING
GNSS
communication Lost connection to the GNSS device.
0A038-0 Antenna
WARNING
GNSS data range Received information from the GNSS device
which is out of range.
0A039-0 Antenna
WARNING
GNSS device
warning Local GNSS device warning.
0A03A-0 Antenna
WARNING
GNSS device error Local GNSS device error.
0A03B-0 Antenna ERROR Azi DDM
shutdown The azimuth motor control has detected one of
the following situations: Extreme temperature,
voltage, current or velocity. The motor was then
shut down. This is usually a temporary situation
and is probably fixed by a restart of the system.
0A03C-0 Antenna ERROR Xel DDM
shutdown As Azi DDM shutdown but detected by the cross-
elevation motor control.
0A03D-0 Antenna ERROR Ele DDM
shutdown As Azi DDM shutdown but detected by the
elevation motor control.
0A03E-0 Antenna ERROR PMM shutdown As Azi DDM shutdown but detected by the
polarisation motor control.
0A03F-0 Antenna
WARNING
AMB timing This indicates a busy situation. It may occur
during installation procedures. No user
interaction is required.
0A040-0 Antenna
WARNING
VIM cable attn The output power cannot be controlled correctly.
Check the Tx chain.
Error code
(ID)
Unit Severity Description Explanation
Table G-1: ADU event messages (Continued)