Furuno FV-110, Руководство оператора

Страница: 165 / 240

STM SatLink 2900 VSAT modem
C-23
Modem configuration requirements
Type the following command in a modem console to set up the STM Satlink 2900 modem
to use the FV-110:
Command Description
odu antctrl waitstablize 300 This configures the antenna stability tries
which is the amount of times the modem
should try to logon before it tries the next
beam in its transponder list.
odu antctrl periodictime 5 This configures the polling frequency in
seconds between the modem and ACU.
odu antctrl port 0 (zero) This configures the IP communication port
to default (5990). Use the command odu
antenna to configure the modem with FV-
110.
odu antenna 30 This configures the antenna type to a
FURUNO antenna.
NOTE: odu antenna 52 is supported from
modem software 16.0.0 or higher. Use the
command odu txtype to set the BUC for
FV-110.
odu txtype 62 This configures the BUC type to a
FURUNO BUC.
NOTE: odu txtype 63 is supported from
modem software 16.0.0 or higher. Use the
command odu lnb to set the LNB for FV-
110.
odu lnb 62 This configures the LNB type to FURUNO
LNB.
NOTE: lnb 63 is supported from modem
software 16.0.0. or higher.
odu antctrl enable all This will enable the communication
between the modem and ACU including
GPS input.
dvb rx autostart on This will enable modem rx.
dvb tx autostart on This will enable modem tx. Save the new
ODU Configuration:
save config This will save the above settings to flash in
the modem. And restart the modem:
restart
Table C-8: Configuration of the STM SatLink 2900 VSAT modem