FujiFilm X-Pro1, Руководство по обслуживанию

Страница: 99 / 132

Confidential: FUJIFILM Service Center Use Only
X-Pro1 Service Manual
3-39
<Step 1>
In the adjustment item select screen, select [F12]: End Setting.
<Step 2>
[Checking End Setting]
Check the details and then press the [Enter] key to proceed.
<Step 3>
[Destination setting]
Look at the 3rd digit from the left in the camera's serial number
and then press the corresponding key.
Selected key Destination 3rd digit in serial no.
J J-model 0 to 8
U US-model A to H,J,K
W E1/EG/EE/RU/AS/EU-model L to N,P to V
C CH-model W to Z
<Step 4>
[Checking the USB_ID and destination]
Check the details and then press the [Enter] key to proceed.
<Step 5>
[Ending Adjustment]
(1) Turn the camera off.
(2) Disconnect the power cord from the camera.
(3) Disconnect the USB cable from the camera.
When you have completed these steps, press the [Enter] key.
After the "OK" screen display, the Adjustment Software
Start-up Screen reappears.
(When adjust the same camera again, switch camera power off
once, and please switch camera power on with a jig mode
again.)
Destination setting
The destination is selected from an undermentioned list,
according to third character from left side of the serial number.
The third character
<J> J-model 0 to 8
<U> US-model A to H,J,K
<W> E1/EG/EE/RU/AS/EU-model L to N,P to V
<C> CH-model W to Z
592D36323831110216E7211Z110001
Selected X-Pro1 J-model.
Press the [Enter] key!
X-PRO1 Adjustment completed.
1) Turn off power switch.
2) Remove the Power cable (or jig) from the camera.
3) Remove USB cable from the camera.
4) Press the [Enter] key.
--> The adjustment software returns to Start-Up screen
After press the [Enter] key.
End Setting
The End settings consist of the destination setting,
the USB_ID write, and product mode settings
(= Mass Storage recognition).
Press the [Enter] key.