FujiFilm X-Pro1, Руководство по обслуживанию

Страница: 109 / 132

Confidential: FUJIFILM Service Center Use Only
X-Pro1 Service Manual
4-9
4-6. CMOS Cleaning and Inspection Procedures
CMOS is incorporated with this model as an image sensor. Dust etc. could stick to the CMOS and depending on shooting conditions
and the type of subject, it could be recorded in images.
If it is the case, the CMOS needs to be cleaned.
4-6-1. Visual Inspection for Dusts and Cleaning method
<Step 1>
Check if the camera is switched off and remove the battery.
<Step 2>
Remove the interchangeable lens from the camera.
<Step 3>
Hold the camera so that light goes to the CMOS and check if there are dusts on the CMOS surface either visually or by using a
microscope.
If dusts can be seen, use a blower to remove it ([Note]).
If the dusts cannot be removed using the blower, wipe the CMOS with a lens cleaner (OLYMPUS HYPER CLEAN EE-3310 or
Equivalent goods) and ZS00172-100 CLEANING PAPER or Equivalent goods.
Do not use a blower with a brush.
Using a blower-brush to clean the CMOS could scratch the CMOS surface.
[Note]
When swiping the CMOS, note that any metallic dusts on the CMOS surface will cause scratches in the CMOS surface during cleaning.
4-6-2. Installation of X-Pro1 W Dust Inspection Soft Ver.*.**
<Step 1>
Download the inspection software from WEB and install the
software in a PC.
We have uploaded the “
X-Pro1 W Dust Inspection Soft Ver.*.**
(ZJ02093-***.zip)
” on our website:
(https://denhin.fujifilm.co.jp/csg_en/index.htm).
<Step 2>
“
ZJ02093
-***” is a compressed file of “ZIP”.
The “ZJ02093-***” folder can be decompressed by “Compression
software”.
Copy the “ZJ02093-***” folder to the “C” drive in the PC.
<Step 3>
Double-click the inspection software installer file of “Setup_X-
Pro1_W_DustInspection_***.exe” in the “ZJ02093-***” folder.
<Step 4>
When the window in the right appears, click [Next].
X-Pro1 W Dust Inspection Soft Ver.*.** ZJ02093-***.zip


: Revised