FujiFilm X-Pro1, Руководство по обслуживанию

Страница: 104 / 132

Confidential: FUJIFILM Service Center Use Only
X-Pro1 Service Manual
4-4
14 Erase mode check Erase (1) Select
“
Erase
”
->
“
ALL FRAMES
”
from the menu
and then press the
“
OK
”
button.
(2) Select "OK" and press the
“
OK
”
button.
(3) Turn the camera off.
(4) Disconnect the SD card from the
camera.
(1) Check that an erase message such
as the following appears:
Overseas:
“
ERASE ALL OK?
”
China:
“
OK?
”
(2) Check that the recorded images are
erased.
15 Playback mode
check
Playback (1) Insert a LCD INSPECTION SD card.
(2) Turn the camera on.
(3) If a message prompting the user to
set the date appears, press the butt
on specified on the right.
(4) Start up in playback mode.
(5) Check the playback image.
(3) <DISP/BACK>
(5) Check that the last image shot
appears, regardless of whether it
is automatic or manual. Check that
the date is displayed in the YYYY.
MM.DD format. ZJ00855-100
ZPU0512-100
16 LCD dust/defect
check
Playback (1) Play back a completely black image.
(2) Play back a completely white (75%)
image. (1) Check that there are no noticeable
dust flecks or stains (bright spots,
smears, flashing points, etc.) on the
screen. ZJ00885-100
17 EVF dust/defect
check
Playback (1) Change to EVF display.
(2) Play back a completely white (75%)
image.
(3) Play back a completely black image. (1) Push the VIEW MODE button.
(2) Check that there are no noticeable
dust flecks or stains (bright spots,
smears, flashing points, etc.) on the
screen. ZJ00885-100
18 Eye sensor check Playback (1) Set the Eye Sensor mode.
(2) Bring eyes close to EVF in a state
displayed by LCD.
(3) Keep away eyes from EVF.
(4) Turn the camera off. (1) Push the VIEW MODE button and turn
on the Eye Sensor.
(2) Displayed by EVF.
(3) Displayed by LCD.
19 Battery low check P mode (1) Set the power supply voltage.
(2) Select the mode dial setting.
(3) Turn the camera on.
(4) Set the power supply voltage.
(5) Turn the camera off.
(6) Remove battery and am connected
again once after progress more than
ten seconds. (1) 7.80 V ± 0.10 V
(2) Mode: IRIS AUTO/SS AUTO.
(4) 6.40 V
± 0.04V
Check that the battery-low warning
(pre-end) appears.
(5) Check the camera turns off.
ZJ01936-100
20 Current
consumption check
P mode (1) Set the power supply voltage.
(2) Select the mode dial setting.
(3) Turn the camera on.
(4) Check the Macro mode.
(5) Macro mode is set as off.
(6) After the LCD live image appears,
check the current consumption. (1) 7.80 V ± 0.10 V
(2) Mode: IRIS AUTO/SS AUTO.
AF Mode: AF-S.
(4) Backup check.
(6) 500 mA or less
ZJ01936-100