FujiFilm X-Pro1, Руководство по обслуживанию

Страница: 94 / 132

Confidential: FUJIFILM Service Center Use Only
X-Pro1 Service Manual
<Step 1>
In the adjustment item select screen, select [F1]: Battery Voltage Adjustment.
<Step 2>
[Preparing for Battery Voltage Adjustment]
Launch the adjustment software and connect the PC to the
camera as shown in the figure before establishing
communication between them.
* If you are not using the battery jig, briefly pause the
adjustment software (Ctrl+A) and then proceed to the "Jig
Mode Setup Screen" in the adjustment software.
Set the digital voltmeter to voltage measurement mode and
then connect the digital voltmeter to the battery jig clip.
Check the digital voltmeter to ensure that the regulated
voltage is set to 7.2V. Then set the camera in the battery jig
and again turn it on in Jig mode. Then proceed to Battery
Voltage Adjustment.
When you have completed the preparations, press the [Enter]
key to proceed.
Battery Voltage Adjustment
<Preparations>
1. Check that the NP-W126 Battery jig and the camera are connected.
* If not, return to the Jig Mode Setup screen,
and connect the NP-W126 Battery jig and the camera.
2. Supply power (7.2V) to the camera from
the [NP-W126 Battery jig].
When preparations are complete, press the [Enter] key on the PC.
->Lens is extended when the [Enter] key is pressed.
<Step 3>
BATT_END
Apply an input voltage of 6.20V(+0.02V/-0.00V) in the battery jig.
When preparations are complete, press the [Enter] key.
[BATT_END]
Adjust the voltage from the regulated power supply so that
[6.20V (+0.02V/-0.00V)] is displayed on the digital voltmeter.
When you have completed the preparations, press the [Enter]
key to proceed.
<Step 4>
[BATT_AC]
Adjust the voltage from the regulated power supply so that
[8.65V(
±
0.1V)] is displayed on the digital voltmeter.
When you have completed the preparations, press the [Enter]
key to proceed.
BATT_AC
Apply an input voltage of 8.65V(+0.02V/-0.00V) in the battery jig.
When preparations are complete, press the [Enter] key.
Revised: 26.June.2012
3-34