FujiFilm X-Pro1, Руководство по обслуживанию

Страница: 65 / 132

Confidential: FUJIFILM Service Center Use Only
X-Pro1 Service Manual
3-5
3-4. Calibration method of pattern box
<Use the pattern box for Camera adjustment>
Turn on the power supply in the pattern box.
Afterwards, wait for about ten minutes so that the source of light may stabilize.
(1) Brightness
160
±
5cd/m2 (with LB145 filter)
No chart, center of pattern box
Minolta brightness meter LS-110 or equivalent
* Calibration method
Place the filter (LB145) against the pattern box. With
the filter (LB145) in contact with the brightness meter,
adjust the pattern box brightness to 160
±
5cd/m
2
.
(2) Color temperature
6100
±
50K (with LB145 filter)
No chart, center of pattern box
Minolta color meter IIIF or equivalent
* Calibration method
Place the filter (LB145) against the pattern box. With
the filter (LB145) in contact with the color temperature
meter, adjust the pattern box color temperature to 6100
±
50K.
3-5. Adjustment software installation
3-5-1. Installation of DSC jig driver
* Since this camera uses the USB for communications with the personal computer, in order to start the PC adjustment
software, [the DSC jig driver] needs to be installed in the personal computer beforehand.
* The DSC jig driver is the same as that for the FinePix S7000, so if this jig driver software is already installed in the personal
computer, it is not necessary to install it. The procedure is given below.
<Step 1>
DSC jig driver (ZJ00684-100.ZIP) is downloaded from Web
server (https://denhin.fujifilm.co.jp/csg_en/Adjustment.htm).
<Step 2>
Defrost the downloaded compression software
<Step 3>
Double-click setup.exe in the folder of defrosted
ZJ00684-100 and install Fuji FILM DSC Jig Driver as
follows.
<Step 4>
Install the software in [C:\ProgramFiles\Fjig] according to the
instructions on the PC's screen.
Calibration method of pattern box