Foma PushTalk SH902i, Руководство пользователя

Страница: 54 / 568

52
Cal
lin
g
/Recei
vi
n
g
M
aki
n
g
C
al
ls
Check that there are sufficient battery and signal levels.
J
Checking the signal strength
Approximate signal strength (level) appears.
Making Calls
1
In stand-by, dial the phone number starting with the area code.
Always dial the area code, even when the number is in the same area.
Dial up to 80 digits. When the number exceeds 13 digits, it appears on two lines.
When the number exceeds 26 digits, the last 26 digits appear in two lines.
2
Press
s
.
When name and
still picture are
saved in the
phonebook
Unlike ordinary telephones, mobile phones send call tones in short beeps before
the standard ring tone.
h
appears during a voice call.
Phone number and name appear if saved in phonebook. Image also appears if
set in advance.
When the other party is busy, there is a busy signal. Press
H
to disconnect
and try again later.
When a guidance message plays requesting caller ID, the other party has Caller
ID Request Service set to
Activate . Set caller ID and call again. (
n
P. 49,
P. 56)
3
Press
H
after the call.
When
A
appears, the handset is outside the service area or in a
place with no signal. Move to a place where the icon disappears.
The call may be interrupted even when the signal is strong (
]
appears) and you are not moving.
When
g
appears, the handset is in Self mode (
n
P. 162).
Note
Calls can be made even when steps 1 and 2 are reversed. If no operations are performed for five seconds
after dialing, the call is made.
Enter 80 digits or more when sending a message using touch-tone signals (
n
P. 57). (Deletes entered
digits from the beginning.)
During a call, approximate call duration appears on the screen.
When the call duration exceeds 9:59:59, the display resets to 0:00.
The FOMA terminal may become warm after continuous use. This is not a malfunction.
Do not cover the internal antenna area when making a call.
International
(enter
+ )
Press
0
(for 1+ seconds)
→
enter other party’s number.
When + is entered, the phone number after + is called.
Mobile phone Enter other party’s number (090-XXXX-XXXX,
080-XXXX-XXXX) (11 digits).
PHS Enter other party’s number (070-XXXX-XXXX) (11 digits).
When a mistake
is made while
dialing Press
c
to erase the last digit.
Press
c
for 1+ seconds to erase all digits.
(The stand-by display reappears.)
Strong Weak
] n o
A
dv30̲e.book Page 52 Tuesday, November 22, 2005 3:21 PM