Document #15140 Rev.G 01/02/02 P/N 15140:G
49
Default Programming
Year
After entering the last digit corresponding to minutes (far right digit), the display will read 1994 with the digit 9 (sec-
ond from the right) flashing. Press
[ENTER/STORE]
if the 9 is acceptable. The digit farthest right will begin flash-
ing. Enter the appropriate digit corresponding to the last digit of the current year and press the
[ENTER/STORE]
key to complete programming of the year.
Note that changing to the year 2000 can be accomplished by entering ‘0’ while the second digit from the right is
flashing, followed by the
[ENTER/STORE]
key. The two digits to the left will change to ‘20’ and the digit farthest
right will begin flashing.
Enter the appropriate digit corresponding to the last digit of the year (i.e. ‘0’ for the year
2000) and press the
[ENTER/STORE]
key to complete programming of the year.
Month/Day
After the year is entered, the display will show four digits representing the month and day of the software release
date. The month is represented by the two digits on the left and the day by the two digits on the right. The digit on
the far left will be flashing. The month and day are set the same way as the hours and minutes. Once the last digit
corresponding to the day is entered, the display will show the contents of address '00'. The real-time clock/calendar
keeps track of leap years automatically.
Note that the software for the MS-5024UD operates the internal clock based upon 60Hz. The software for the
MS-5024UDE operates the internal clock based upon 50Hz.
End Programming
Exit Programming Mode by pressing
MODE
, followed by the 4-digit code corresponding to an alternate mode of
operation, then press
[ENTER/STORE]
.
During Program Mode, if no key is pressed within 10 minutes, the panel will return to Normal Mode.
3.4
Default Programming
To return all program entries to their factory original settings, perform the following steps only when the system is
idle in Normal standby condition:
Press the
MODE
key followed by the four digit code
3337
and press the
[ENTER/STORE]
key.
☛
3337
spells DEFP (
DEF
ault
P
rogramming) on a Touch-Tone
®
phone
If an incorrect key is pressed, reenter the proper 4-digit code
before
pressing the
[ENTER/STORE]
key.
Within five seconds, repeat this entry by again pressing the
MODE
key followed by the 4-digit code
3337
and press-
ing the
[ENTER/STORE]
key. The display will read
3337
while the E
2
nonvolatile memory (storage area for all
programming options) is being reprogrammed with the original default settings. When reprogramming is complete,
the display will be blank.
