Festo SFC-LAC CO Series, Руководство пользователя

Страница: 82 / 328

4. The control panel (only type SFC−LAC−...−H2−...)
4−12
Festo P.BE−SFC−LAC−CO−EN en 0708NH
For starting positioning travel or reference travel:
·
Note the instructions in section 5.2.10 (test run) or 5.2.3
to 5.2.5 (reference travel).
1. Select the menu [Positioning] in the main menu.
2. Select a menu command:
[Positioning] Description Note
[Homing] Reference travel as per the set
homing method. Setting the parameters: see
[Settings] [Homing paramet.]
[Move posit. set] Positioning run for testing a
particular position record in the
position record table. Parametrizing and referencing must
have been completed.
[Demo posit. tab] Positioning cycle (continuous loop)
for testing all position sets in the
position set table. Parametrizing and referencing must
have been completed.
There must be at least two position
records in the memory.
Tab.4/4: [Positioning] menu
During the positioning run the following information is
displayed:
the active position record, Pos...
the target position, x
t
the positioning speed, v
the current position, x
a
EMERG.
STOP With <Menu> you can interrupt the positioning
procedure (
>
Error mode EMERG.STOP).
Menu
DEMO
STOP With <Enter> you can interrupt the positioning
cycle [Demo posit tab]. The current positio
ning set will be executed before the axis
stops. If you restart, the run will begin with
position record 1.
Enter
} Positioning
Homing
Move posit. set
Demo posit. tab
...
Pos 1
X
t
= 100.00 mm
v = 20 mm/s
X
a
= 90.00 mm
EMERG.STOP<Menu>