![background image](http://html1.mh-extra.com/html/feig-electronic/id-isc-lru3000/id-isc-lru3000_manual_3881201037.webp)
OBID
i-scan
®
UHF
Manual
ID ISC.LRU3000/3500
FEIG ELECTRONIC GmbH
Page 37 of 193
H90202-7e-ID-B.docx
OUT2-TIME and REL3-TIME:
(DigitalIO.Output.No2.SettlingTime)
(DigitalIO.Relay.No3.SettlingTime)
Defines the holding time of the digital output OUT2 / REL 3. If the Reader receives a valid
Transponder response the antenna assigned to the output by
(Assignment – output to antenna read event)
is activated for the value in OUT2 / REL3-
TIME.
If OUT2 / REL3-TIME is zero the function is disabled.
If OUT2 / REL3 is high in idle mode, OUT2 / REL3 will low for OUT2 / REL3-TIME.
If the flash mode is enabled, the output goes low.
Range: 0x00 ... 0xFF ( * 100ms) = 0s ... 25,6s.
NOTE:
Automated Reader Modes (reading of serial number and data):
If the serial number was read OK and the data not, no data set will be transferred, but
the assigned RELx and / or the OUTx will be active.
7.3.1. Dedicated Input / Output Functions
IN1 is reserved for the trigger, if the trigger is enabled in
. The LED’s are used
for system monitoring.
LED
Color
Dedicated Function
1
green
1. 1 second blink.
2. Alternately blink with LED2 after an EEPROM error.
2
blue
1. The RF interface has a faultless communication with a Trans-
ponder.
2. Alternately blink with LED1 after an EEPROM error.
3
yellow
The interface sends data to the host or Application and communica-
tion Board.
NOTE:
LED1 (green) and LED2 (blue) are blinking alternately if a read error of the EEPROM oc-
curred after power-up or a