![background image](http://html1.mh-extra.com/html/feig-electronic/id-isc-lru3000/id-isc-lru3000_manual_3881201092.webp)
OBID
i-scan
®
UHF
Manual
ID ISC.LRU3000/3500
FEIG ELECTRONIC GmbH
Page 92 of 193
H90202-7e-ID-B.docx
KEEPALIVE: (HostInterface.WLAN.Keepalive.Enable)
0x00: keepalive option disabled
0x01: keepalive option enabled
KEEP-CNT: (HostInterface.WLAN.Keepalive.RetransmissionCount)
Specify the maximum number of retransmissions. This is the number of times that the
reader re-transmits a keepalive packet to the host to check for connectivity. The valid range
is 1..255.
KEEP-IDLE: (HostInterface.WLAN.Keepalive.IdleTime)
The time the connection needs to remain idle before the reader starts sending keepalive
probes. The valid range is 1..65535 sec.
KEEP-INTERVAL: (HostInterface.WLAN.Keepalive.IntervalTime)
Set the Keepalive Interval. This is the polling frequency used to determine if a keepalive ex-
change is needed. This interval is used when the connection failed. The valid range is
1..65535 sec.
AD-HOC CHANNEL: (HostInterface.WLAN.AdHocChannel)
Selects the WLAN Channel (1..13) for Ad-Hoc network type.
MODE:
The reader can be integrated in a managed WLAN network with an Access Point or in an
Ad-Hoc (Peer-to-Peer) network without an Access Point. If an Ad-Hoc network type is se-
lected, then special settings in CFG 74 (SSID-LEN, SSID) are required.
Bit
7
6
5
4
3
2
1
0
Function
0
0
0
0
0
0
0
NW-TYPE
NW-TYPE: (HostInterface.WLAN.NetworkType)
b0:
network with Access Point
b1:
Ad-Hoc (Peer-to-Peer) network
NOTE:
The command
8.5. [0x8C] Reset Configuration
Changing of this parameter only becomes effective after writing /saving this configuration
block to EEPROM and a