Fayat Group Bomag MPH 122-2, Инструкция по эксплуатации и обслуживанию, Страница: 20 / 198

Safety regulations
BOMAG 20 MPH 122-2
Ensure sufficient ventilation, especially if the bat-
tery is to be charged in a closed room.
Working on the fuel system
Avoid open fire, do not smoke, do not spill any fuel.
Do not inhale any fuel fumes.
Catch running out fuel, do not let it seep into the
ground and dispose off environmentally.
Working on the rotor
Open the hood gate completely and secure it with
bolt and spring clip.
Do not prop the rotor hood with any means – dan-
ger to life!
For maintenance work on rotor and rotor hood, the
rotor hood must always be secured on both sides
with hood securing bolts.
Wear goggles and gloves to change the cutting
teeth, since hard metal chips may splinter off when
knocking the teeth in or out.
Working on the air conditioning
Faults on the air conditioning should only be rem-
edied by professional personnel.
According to the regulation for pressure reservoirs
all pressure reservoirs must be repeatedly inspect-
ed by a specialist.
In connection with this inspection the drier/collec-
tor unit must be visually examined twice every
year. During these inspections special attention
must be paid to corrosion and mechanical dam-
age.
Do not perform welding work in the vicinity of the
air conditioning. Danger of explosion!
Do not clean the condenser in the air conditioning
system with a hot water jet. Danger of explosion!
Do not release refrigerant into the atmosphere, but
dispose of environmentally.
Cleaning work
Do not perform cleaning work while the motor is
running.
Do not use gasoline or other easily inflammable
substances for cleaning.
When cleaning with steam cleaning equipment do
not subject electrical parts and insulation material
to the direct jet of water, or cover it beforehand.
Do not guide the water jet into the exhaust and into
the air filter.
When working with asphalt, bitumen or lime clean
engine and hydraulic oil coolers at regular inter-
vals.
After maintenance work
After all maintenance work is completed reinstall
all guards and safety installations.
Repair
Mark a defective machine by attaching a warning
tag to the steering wheel.
Repair work must only be performed by qualified
and authorized persons. Use our repair instruc-
tions for this work.
Exhaust gases are highly dangerous! Always en-
sure an adequate supply of fresh air when starting
in closed rooms!
Do not work on the fuel system while the engine is
running - danger to life!
The system is under high pressure! Keep away
from leakages in the high pressure system, be-
cause fuel squirting out may cause severe injury.
After shutting down the engine wait for another
minute, until the pressure has dropped to a per-
missible level. In case of leakages you should con-
tact the Service Department of the engine
manufacturer and refrain from starting the engine.
Always remove the main battery switch before
starting welding work on the machine. Disconnect
the batteries and connect negative and positive
cables. Pull the plugs of ESX-control and Dios-
module (water injection).
Information and safety stickers/decals
on the machine
Keep stickers/decals in good and legible condition
(see spare parts catalogue) and comply with their
meaning.
Replace damaged and illegible stickers/decals im-
mediately.