SC 10 DISASSEMBLY
GENERAL
1)
Remove the body and wheels. We suggest you store the body clips by re-
installing them in the mounts, and the wheel nuts by putting them back on
the axles. We will not insult you with photos for the first few instructions…
2)
Remove the gear cover. You will not need this part or the screws. Take
the pinion off the motor, then unsolder and remove the motor. You will
need the motor and its mounting screws, and will want to save the pinion,
so we suggest you put the pinion away and put the screws back in the
motor for storage.
3)
Remove the electronics. This includes the battery, servo, ESC, radio
receiver, and antenna tube. Save these parts for re-use. Do not remove
the servo mounts from the servo, simply remove the two flat head screws
from underneath the chassis. Save the screws by re-installing them into
the servo mounts. Disconnect the servo link from the steering bellcrank;
leave the link connected to the servo horn. Do not disconnect the horn
from the servo. The battery strap may be discarded. We suggest you
clean the servo tape off the electronics.
Your truck should now look like this photo:
FRONT END