E12) Slide the control arms on the
hinge pins. Shock mounting
holes to the rear.
E13) Check the set-up sheet and tuning section to determine which toe-in bar
(XF3211) you will use. Select the 3
o
or 4
o
toe-in bar and slide it onto the
hinge pins. It will go above the chassis.
E14) In this photo we have inserted a
pencil between the toe-in bar and
the chassis to illustrate how the bar
will slide up and down.
E15) Check the set-up sheet and Tuning Section to determine how much anti-
squat you will run. There is a packet of small round shims in Bag E, four
0.060” thick (long arrows) and two 0.030” thick (short arrows) (XF3250).
This allows 6 different anti-squat settings: 0, .030”, .060”, .090”, .120”,
and .150” Place two sets of shims between the bar and chassis. Here we
show .090”.