D4)
When installed properly, the brace and
cradle look like this.
ONWARD TO THE TRANSMISSION!
D5)
Install the motor plate brace (XF1130) with two 4-40 X 3/8” flat head
screws coming up from under the chassis. Leave them finger tight for
now. Note that the brace is offset to the left.
D6)
Install the rear bulkhead (XF1310) onto the rear of the transmission cradle
with a 4-40 X 1/2” cap head screw (long arrow). The bulkhead should
slide over the two screws extending up through the cradle. The two holes
at the bottom rear of the bulkhead are not used on the SCX – 60CF.
D7)
Gather together two 4-40 X 3/8” cap
head screws, two 4-40 mini nuts
(XF6073), and four #4 flat washers
(XF6080). Check the tuning section
and set-up sheet to determine which
transmission shims (XF5702) you will
use, get those four shims out of the
bag, and save the others. Here we are