Installation and Operation, cont’d
TLP 350CV • Installation and Operation
2-4
Cutting the Table
After verifying and checking dimensions and preparing the proper template,
cut a hole in the surface of the furniture where the enclosure will be installed.
The preferred and recommended method for preparing the table for square
Cable Cubby models is to use the appropriate Extron routing template and a router.
C
The opening in the table for the TLP 350CV should be cut only by licensed
and bonded craftspeople. Exercise care to prevent scarring or damaging
the furniture.
The surfaces of the Cable Cubby enclosure have screws and other
protruding hardware that could damage fine furniture. While assembling
or otherwise working on the enclosure, do not rest it on unprotected
furniture.
Alternatively, for any model, use a paper cut-out template (
) and a
sabre saw or keyhole saw.
Preparing the Routing Template
Metal templates are available from Extron for the Cable Cubby products. See
"TLP 350CV Routing Template" in the Accessories list in
numbers. Extron recommends using this template as a guide to cut the hole in the
table where the TLP 350CV will be installed.
1.
Cut 1/2 inch x 4 inch strips of soft, finished lumber at least long enough to
span the distance between the desired installation location on the mounting
surface and the edges of the mounting surface (figure 2-1).
These strips raise the routing template above the mounting surface to provide
room for the router’s collar, protect the mounting surface, and extend the
routing template’s reach so that it can be clamped to the edge of the surface.
Mounting
Surface
Edge
Mounting
Surface
Edge
Wood Thickness
0.5" / 1.3 cm
Width of Mounting Surf
ace
Routing Template
Wood Strip
Height
4" / 10.2 cm
Minimum
4 Screws
Wood
Strips
Figure 2-1 — Prepared TLP 350CV mounting template
2.
Using four or more short wood screws, secure the mounting template to the
lumber strips.
C
Do not allow the wood screws to protrude through the bottom of the
wooden strips. Protruding screws will mar the table when the template is
used.
Содержание 60-1017-0200
