Extron electronics 60-1017-0200, Руководство пользователя

Страница: 57 / 60

B-5
TLP 350CV • Reset Modes and Button Replacement
Button Replacement
To replace one or more buttons on the front panel of the TLP 350CV, follow these
instructions.
1. Remove power from the TLP 350CV by removing the power cord or
unplugging the power supply.
2. The faceplate is snapped on and held in four places, two on top and two at the
bottom of the faceplate. Using an Extron Tweeker, gently push down on the
two top tabs as shown to release the faceplate.
Release tabs in
two Places
3. The faceplate is still captured by two clips on the bottom. While rotating the
faceplate away from the panel, push it down slightly to release the two clips.
N
Prior to removing the faceplate it may be helpful to rotate the touch panel
forward (as if closing it) to about a 30 ° angle to prevent the buttons from falling
out of the faceplate.
4. Replace all desired buttons making certain the text has the proper orientation.
5. The buttons easily fall from the faceplate when it is tilted past vertical. If the
touch panel was not rotated prior to this, rotate it towards the front of the
enclosure to a 30° angle now.
6. Replace the faceplate from the top. First slide the bottom into the recessed
space on the top of the enclosure, then snap the top two catches released in
step 2 , into place.
7. While gently holding the faceplate in place, rotate the panel to its normal open
position.
8. Snap the bottom of the faceplate in place to complete the button replacement.
Be certain both bottom catches snap into place. If alignment does not seem
correct, repeat the installation of the faceplate from step 5.
9. Connect power and ensure all buttons function properly. If they do not, begin
the button replacement again and make certain the buttons remain properly
seated during faceplate installation.