Extron electronics 60-1017-0200, Руководство пользователя

Страница: 13 / 60

2-3
TLP 350CV • Installation and Operation
Obtain Cutout Dimensions
Determine the optimum location for the TLP 350CV keeping in mind the size
of the enclosure that will be below the table and also the ease of operation for a
user. Cutout dimensions are available as a router guide, printed dimensions for
a CNC wood router and a cutout template. If using the router guide, follow the
instructions included with it. Printed dimensions are available in Appendix A .
W
Make certain the correct cutout dimensions are being used before
proceeding to the next step. Extron is not responsible for improperly
positioned Cable Cubby models.
W
Wear safety glasses when operating power equipment. Failure to comply
can result in eye injury.
Double-check before you cut:
• If using a routing template, be certain it is the correct template for the
TLP 350CV.
• If using a CNC router, be certain the correct dimensions for the TLP 350CV are
entered.
• If using a reciprocating saw or jigsaw, be certain to use the correct paper
template for the TLP 350CV.
• Be certain the cut is laid out in the desired location.
• Be certain the cut is laid out so the connector access side is oriented as desired.
Preparing the Table
A hand router using the routing template or a CNC wood router are the most
accurate, preferred, and recommended methods for preparing the table for the
TLP 350CV. After verifying and checking dimensions, prepare required templates
based on the method of cut.
C The opening in the table for the Cable Cubby should be cut only by
licensed and bonded craftspeople. Exercise care to prevent scarring or
damaging the furniture.
The surfaces of the Cable Cubby enclosure have screws and other
protruding hardware that could damage fine furniture. Do not rest the
enclosure on unprotected furniture.
C
Ensure the table surface is at least 3/8 inch (0.375 in) (0.95 cm) thick.
RECOMMENDED — A hand router and the Extron TLP 350CV
routing template, part #70-694-01. Refer to the Routing Template
User’s Manual , available on the Extron Web site, www.extron.com or
"Preparing the Router Template" on page 2-4 , to prepare the template and use
the template to cut the hole.
RECOMMENDED — A CNC wood router and the exact cut-out dimensions:
7.50 +0.00/-0.02 in W x 6.00 +0.00/-0.02 in D
(19.05 +0.00/-0.05 cm W x 15.24 +0.00/-0.05 cm D)
N
The underlined dimension is the unit’s connector or AAP access side.
Acceptable — A reciprocating saw or jigsaw and a paper cut-out template
(available on the Extron Web site, www.extron.com .)