Extron electronics 60-1017-0200, Руководство пользователя

Страница: 15 / 60

2-5
TLP 350CV • Installation and Operation
Preparing the Table with a Router
Prepare the table with a router as follows:
C The routing templates for the various Cable Cubby models are not
interchangeable. If the wrong template is used, the hole will be the
incorrect size. If a larger template than required is used, the cut will result
in gaps in the table surface on either side of the enclosure.
C
Ensure that only the wooden strips on the routing template contact the
furniture. Failure to do so may mar the furniture.
1. Mark the desired mounting location on the tabletop or other installation
surface.
2. Place the mounting template assembly on the table, centered on the mounting
location. Angle the template for the optimum positioning. If necessary,
use a square to ensure the template is properly positioned. Extron is not
responsible for an improperly positioned Cable Cubby.
3. Once the template assembly is positioned properly, secure the assembly to the
table with C-clamps.
W
Wear safety glasses when operating the router. Failure to comply can
result in eye injury.
4. Using a router with a 5/8 inch (or 16 mm) outside diameter guide bushing
and a 1/2 inch (or 12 mm or 12.7 mm) diameter straight router bit, carefully
cut the opening in the surface (figure 2-2).
Figure 2-2 — Cutting the opening with a router
5. Remove the C-clamps and the routing template.
N The metal routing template is reusable. Do not discard this template when the
installation is complete. Save it for installing Cable Cubby models of the same
size.