NexLog Recorder User Manual v2.2.0
119
5. Recorder Operation
5.1. Starting and Shutting Down
To start the recorder, use the front panel power switch, the switch is behind the
locked door on which the display is mounted on touch screen units, and behind
the blank front panel door on non-touch screen units. Do not hold the switch for
more than one second.
To shut down the recorder, you can perform a controlled shutdown or a forced
shutdown. In most circumstances, you should only perform a controlled
shutdown. This allows the recorder to close all open files and complete current
database operations before shutdown. A forced shutdown can result in
corrupted files and loss of data. It can also damage any archive media in the
process of being written, and possibly leave either gaps or duplications in your
archives. (In addition, Eventide strongly recommends using the recorder with a
UPS to allow a controlled shutdown in the event of a power failure.)
Important!
A forced shutdown can result in corrupted files and loss of data.
To perform a controlled shutdown of the recorder:
Press Setup.
Select Power Off.
Select shutdown and respond “OK” to the prompt.
If for some reason, it is not possible to use this standard method to perform a
shutdown, a controlled shutdown can still be accomplished using the following,
somewhat riskier, alternative.
Use the front panel power switch to initiate a controlled shutdown by pushing
the switch for up to one second.
Eventide does not recommend forcing a shutdown, but if it becomes necessary
follow these steps.
Important!
A forced shutdown can result in corrupted files and loss of data.
To perform a forced shutdown of the recorder:
Push and hold the power switch for 10 seconds until it shuts down.
An alternative way to perform a forced shutdown is to turn off the power
supplies from the back panel, or unplug the power supplies.