Aurorean Installation & Service Guide
65
Chapter 3
Configuring the Remote ANG-3000/7000
Installing Software & Setting Networking Configurables
Configuring the Remote ANG-3000/7000
Since you have already configured General values for the ANG, you are ready
to complete configuration of the Network Gateway.
Setting Routing Parameters
To set routing parameters of the remote ANG, perform the following steps:
1
Click on the Routing option.
The Routing Configuration window appears with the RIP tab
selected by default as shown in Figure 44. If you do not want to
configure RIP as your routing protocol, skip to “Setting OSPF
Properties” on page 66, otherwise continue with Step 2.
Figure 44
ANG RIP Routing Configuration Window
Setting RIP Properties
If your trusted network uses RIP and you want the ANG to learn and
broadcast RIP routes, perform the following steps:
1
Choose the appropriate radio button to select the following RIP