Aurorean Installation & Service Guide
19
Chapter 2
Mounting the ANG/APS-3000/7000
Mounting & Connecting Systems
Figure 12
Positioning the Rear Bracket on the Rail Assembly
1
Hold the rail assembly against the rack to determine which slots to
use in the brackets. From the rear of the cabinet, hook the front
bracket over the front of the rack.
2
Place the rear bracket so its rack mounting lip is over the back of the
rack.
3
Note which slots align with the two sets of three holes in the rack
section of the rail.
4
Remove the rail assembly from the rack.
Attach the Rear Brackets to the Rail Assemblies
Since you have determined which slots to use on the rear brackets, perform
the following steps to attach the rear brackets to the rail assemblies.
1
Use two 8/32 x 0.38” flathead countersunk Phillips screws, two flat
washers, two lock washers and two nuts to mount the brackets to the
rail assembly in the order shown in Figure 13.
2
Spread the screws as far apart as possible.
3
Attach the brackets so the bracket will slide along the rail assembly.
Rack section
Rear bracket
