53
For MODEM execution;
* I want to synchronise my WTMDs and use the Remote Control SRC-SCADA Software
at the same time. How should I make a connection
?
The same connector (SYNC/SRC SOCKET) socket is used for SRC-SCADA Remote Control and
Synchronized operation.(See 3.7) The terminals/wires(5-6) should be used from the “synchronizing
operation cable” and has to be connected to computer or the modem. This process should be
performed by a technical staff. This cable is provided as an accessory.
* What is the maximum distance could be between my computer and
ThruScan
?
It depends on the Cu-quality/Thinnet of the cable.
With the cable supplied by the factory, you may
have a data communication up to 100 meters.
9.3 OPERATIONAL PROBLEMS
*Does keeping the WTMD without operating for a long time require any adjustment or
maintenance?
Storing in suitable conditions or keeping without operation does not cause any break downs or
require new adjustments. However, failure may occur caused by rechargeable batteries. Because of
this, the storage batteries have to be removed. See section 8.4
*How can I adjust the Sensitivity Level?
It is explained in the manual how to adjust the sensitivity level.
Do not forget that if you increase the sensitivity the level will approach the 0 value.
See Section 4.1.1
*What is the recommended sensitivity level?
The level as the factory default is normally the recommended sensitivity level. However, it is further
advised that the sensitivity level should be adjusted by the user, according to the needs of the
place. See 4.1.1 and 4.1.2
2
1
2
1
6
5
6
5
