35
4.1.23 STATISTICS MENU
This menu is used for viewing recorded statistics information and for
resetting this to zero when needed.
5. SYSTEM OPERATION
ThruScan
is easy to operate however; the unit must be used in a proper way to
ensure correct detection & screening.
The operator (Security Guard-the person responsible for
ThruScan
) must follow the supervisor’s
instructions regarding the use of
WTMD
with necessary response to the alarms.
The operator’s continuous responsibility is to ensure that
ThruScan
always operates according to
the information displayed on the LCD and thus to determine the cause of any alarms.
The operator should ensure that the:
ThruScan
is always operating as required,
Program and sensitivity settings are correctly made,
LED VU display shows minimal interference (environment electromagnetic noise),
Pacing is performed when Green (READY) pacing lights are on,
Operation is realized according to the instructions.
5.1 NORMAL OPERATING MODE
As stated below operating and using
ThruScan
is easy.
Using the MENU, as stated in Section 4 it is very easy for the user;
1.
Turn your
ThruScan
on by pressing the
ON-OFF
button from the Control Panel ensure that
it has been properly programmed and set up as in section 4 above,
2.
Carry out routine functional test (see Section 5.2),
3.
If the daily traffic count is to be reset follow 4.1.6 above,
4.
Ensure persons only enter the gate way when the green pacing lights are illuminated,
5.
Finally if an alarm is generated refer to section 5.3 below.
5.2 ROUTINE TESTS
ThruScan
should be tested daily before use and in addition at any time the unit is moved or
against to the environmental changes.
The actual tests undertaken should be carried out to suit the operational requirements of the user,
an example is as follows;
STATISTICS
IN OUT
ALARM RATE
RUN TIME
ALARM COUNTER
00078
00012
