CHAPTER 8 - PXG600E CONFIGURATION WEB PAGE
59
EATON
PXG600E User Manual • IM02603003E
Rev 5, 11-May-2012 • Firmware Version 5.03:3835
Adding a New Main - Step-By-Step
To add a new Main to the system, follow these procedures:
1.
Click on the
button
(Figure 51, A)
in the device list of the PXG600E
configuration web page.
Figure 51
2.
Select “Main” from the “Create Which Device” drop-down menu
(Figure 52, A)
. Note that if there are no Buses installed on the
PXG600E, “Main” and Bus” are the only devices you will find on the
drop-down menu. If there is at least one Bus installed on the PXG600E,
there will be a variety of devices listed on the “Create Which Device”
menu. Some of the devices that are available are listed in the
Supported Device List on page 263
. This list was current when this
manual was published. The most current list is available on
www.eaton.com/pxg
.
3.
Click on the
button
(Figure 52, B)
to proceed to
Step 5
if you are
satisfied with your selection.
4.
Click on the
button
(Figure 52, C)
to go back to
Step 1
if you wish
to change the selection.
Figure 52
PXG600E-288
A
PXG600E_289
A
B
C
