CHAPTER 8 - PXG600E CONFIGURATION WEB PAGE
119
EATON
PXG600E User Manual • IM02603003E
Rev 5, 11-May-2012 • Firmware Version 5.03:3835
1.
Click on the ACCESS CONTROL link
(Figure 125, A)
in the toolbar of the
PXG600E configuration web page.
NOTICE: The PXG600E ships with Port 502
(Figure 125, B)
assigned for Modbus TCP traffic and should not be changed
unless your application requires this modification.
NOTICE: The PXG600E ships with Port 47808
(Figure 125, C)
assigned for BACnet/IP traffic and should not be changed unless
your application requires this modification.
Figure 125
2.
Note these statements
(Figure 125, D)
on the Access Control page.
Enabling Access Control will prevent all outside computers from
accessing SNMP, Modbus TCP communications, BACnet/IP and
pass-through functionality.
To permit, and limit, communications to computers you trust, enter
those IP addresses or hostnames in the Trusted Hosts box below.
Note: If you specify hostnames of trusted computers, you must
configure the IP address of a DNS server on the Network
Configuration screen.
Disabling Access Control will allow any computer access to SNMP,
Modbus TCP communications, BACnet/IP, and pass-through
functionality.
NOTICE: Follow the instructions in the
Manually Enter IPv4
Address on page 103
to list the IP address of a DNS server.
3.
Click on the “Enable” checkbox
(Figure 125, E)
to enable, or disable,
Access Control.
4.
If Access was enabled, enter the IP, or host name address, of the trusted
host
(Figure 125, G)
and click on the
button
(Figure 125, F)
to add
additional trusted hosts.
5.
When you are done adding all of the trusted hosts, you can SAVE ALL
SETTINGS, VIEW CHANGES or DISCARD CHANGES that you have
made. For details on how to use these functions, see
Common
PXG600E Configuration Functions on page 39
.
PXG600E_360
B
C
E
D
A
F
G