Dynapac CC950, Инструкция по эксплуатации

Страница: 137 / 143

Maintenance - 2000h
4812164101_A.pdf 2022-02-09
Air cleaner filter element - Change
Fig. Air cleaner
2. Element
2
Be sure the reinstall the detached safety shield
after maintenance or checking. Be sure the reinstall the detached safety shield
after maintenance or checking.
Use caution. Wear gloves. Use caution. Wear gloves.
Protective gloves Protective gloves
Replace the air cleaner filter element (2).
Check that hoses and connectors are tightened.
Refer to the engine manual for detailed
instructions. Refer to the engine manual for detailed
instructions.
Dispose of the old filter carefully. Dispose of the old filter carefully.
Hydraulic fluid filter - Change
Fig. Engine compartment, left side
1. Hydraulic fluid filter
1
Remove the filter (1) and deliver to special
waste handling. This is a single-use filter and
cannot be cleaned. Remove the filter (1) and deliver to special
waste handling. This is a single-use filter and
cannot be cleaned.
Thoroughly clean the filter holder sealing surface.
Apply a thin coat of fresh hydraulic fluid to the rubber
gasket on the new filter.
Screw the filter on by hand, firstly until the filter gasket
makes contact with the filter base. Then rotate a
further ½ turn.
Start the engine and check that the filter does not leak.
Do not over-tighten. The seal can be damaged. Do not over-tighten. The seal can be damaged.
Dispose of the old filter carefully. Dispose of the old filter carefully.
127