Dynapac CC950, Инструкция по эксплуатации

Страница: 17 / 143

Safety - when operating
4812164101_A.pdf 2022-02-09
Safety - when operating
Prevent persons from entering or remaining in
the risk zone, i.e. a distance of at least 7 m (23
ft) in all directions from operating machines. Prevent persons from entering or remaining in
the risk zone, i.e. a distance of at least 7 m (23
ft) in all directions from operating machines.
The operator may allow a person to remain in
the risk zone, however he/she must be attentive
and operate the machine only when the person
is fully visible or has given a clear indication of
where he or she is.
The operator may allow a person to remain in
the risk zone, however he/she must be attentive
and operate the machine only when the person
is fully visible or has given a clear indication of
where he or she is.
Avoid driving across a slope. Drive straight up
and down sloping ground. Avoid driving across a slope. Drive straight up
and down sloping ground.
Seated position
Figure. Seat position
1. ROPS
2. Seat belt
2
1
Remain seated at all times when operating the roller.
Always use the seat belt where fitted. Where the
seat belt is not used, there is a great risk that the
operator will be thrown off and land under the
machine if the machine topples over. Always use the seat belt where fitted. Where the
seat belt is not used, there is a great risk that the
operator will be thrown off and land under the
machine if the machine topples over.
The seat belt is standard equipment on rollers fitted
with Roll Over Protective Structure (ROPS) (1).
ROPS should always be in the raised position
when machines with foldable ROPS are operated ROPS should always be in the raised position
when machines with foldable ROPS are operated
Work driving
Dynapac always recommends mounted ROPS
(Roll Over Protective Structure) and seat belt
usage. Dynapac always recommends mounted ROPS
(Roll Over Protective Structure) and seat belt
usage.
On machines with foldable ROPS, make sure that
the ROPS is correctly mounted in the upright
position during all operation.
On machines with foldable ROPS, make sure that
the ROPS is correctly mounted in the upright
position during all operation.
Avoid operating close to edges and ditches and the
like as well as on poor ground conditions that
jeopardizes the bearing strength and capacity to
support the roller. Pay attention to potential obstacles
above the machine, such as overhead cables and the
branches of trees etc.
Pay particular attention to the stability of the substrate
7