Dynapac CC950, Инструкция по эксплуатации

Страница: 68 / 143

Miscellaneous
4812164101_A.pdf 2022-02-09
Load carrier Load carrier
Ensure that: Ensure that:
- When loaded, the vibratory roller is centered laterally on the platform (± 5 cm). - When loaded, the vibratory roller is centered laterally on the platform (± 5 cm).
- The parking brake is applied and in good working condition, and the articulated joint lock is
closed. - The parking brake is applied and in good working condition, and the articulated joint lock is
closed.
- The drum is placed on a rubber liner, so that the static friction between the surfaces is at least
0.6. - The drum is placed on a rubber liner, so that the static friction between the surfaces is at least
0.6.
- The contact surfaces must be clean, wet or dry, and free from frost, ice and snow. If there is a
risk of frost, ice and/or snow the platform has to be salted. - The contact surfaces must be clean, wet or dry, and free from frost, ice and snow. If there is a
risk of frost, ice and/or snow the platform has to be salted.
- The lashing mounts on the load carrier have LC/MSL at least 2 tonnes. - The lashing mounts on the load carrier have LC/MSL at least 2 tonnes.
Lashings Lashings
Ensure that: Ensure that:
- The lashings comprise a lashing strap or chain with a permitted load (LC/MSL) of at least 1.6
tonnes (1,600 daN) and the lashings are well pre-tensioned during the entire transport. - The lashings comprise a lashing strap or chain with a permitted load (LC/MSL) of at least 1.6
tonnes (1,600 daN) and the lashings are well pre-tensioned during the entire transport.
- Each of lashings 1-3 is either a double or two single lashings. A double lashing runs in a sling
through a lashing point or around a machine part and down into two different mounts on the
platform. - Each of lashings 1-3 is either a double or two single lashings. A double lashing runs in a sling
through a lashing point or around a machine part and down into two different mounts on the
platform.
- Lashings in the same direction are placed in different lashing mounts on the trailer. Lashings
that are pulled in opposite directions may be placed in the same lashing mount, however. - Lashings in the same direction are placed in different lashing mounts on the trailer. Lashings
that are pulled in opposite directions may be placed in the same lashing mount, however.
- Lashing 4 ties the two rollers together to one unit. The lashing is drawn from drum to drum or
from lashing eye to lashing eye on the front part as well as the rear part of the rollers. - Lashing 4 ties the two rollers together to one unit. The lashing is drawn from drum to drum or
from lashing eye to lashing eye on the front part as well as the rear part of the rollers.
- The lashings are as short as possible. - The lashings are as short as possible.
- The lashing hooks must not lose grip if the lashings become slack. - The lashing hooks must not lose grip if the lashings become slack.
- The lashings are protected against sharp edges and corners. - The lashings are protected against sharp edges and corners.
- The lashings are located symmetrically in pairs on the right and left sides. - The lashings are located symmetrically in pairs on the right and left sides.
58