14
LP Panelized Baghouse 684LP - 882LP
Installation
Electrical installation (including bonding and grounding of the collector) must be performed by a qualified electrician.
This equipment is not designed to support site ducts, piping, or electrical services. All ducts, piping, or electrical
services must be adequately supported to prevent injury and/or property damage.
Do not install in classified hazardous atmospheres without an enclosure rated for the application.
Service must be performed by trained and qualified maintenance personnel.
Equipment may reach peak sound pressure levels above 80 dB (A). Noise levels should be considered when
selecting collector location.
Location and Site Selection
Equipment location must conform to all codes and standards, should be suitable for the type of dust being handled and should
ensure easy access for service and utility connections. Site selection must account for wind, seismic zone, and other load
conditions.
The equipment must be adequately anchored once in final position. Foundation or support framing must be capable of supporting
dead, live, wind, seismic and other applicable loads. Consult a qualified engineer for final selection of foundation or support
framing.
Provisional Anchor Bolt Recommendations
The quantity of anchor bolts should match the number of holes
provided in the base plates of the collector. Anchor diameter is
typically 1/8-inch less than the baseplate hole diameter. Anchors
should project a minimum of 1 ¾ -inch and account for nut,
washer, baseplate, and shims/grout.
Consider Hilti HIT-HY 200 Anchor Systems or equivalent.
Delivery and Inspection
Upon arrival inspect collector and report any damage to delivery
carrier. File any damage claims with the delivery carrier.
Request a written inspection report from the Claims Inspector to
substantiate all damage claims.
Compare the collector received with the description of product ordered. Report any inconsistencies or incomplete shipments to the
delivery carrier and your Donaldson Torit representative.
Typical Foundation Anchor
Anchor should project a
minimum of 1 3/4-in and
account for nut, washer,
base plate and shims/
grout.
Embedment depth
(suitable for the
physical properties of
the foundation).
