4–22
Managing the DECserver 90L
Reset Command
The Reset command allows you to reset individual ports or server
parameters to their power-up state and run the units self-test. Resetting
the server sets all port and server parameters to their power-up state and
disconnects all sessions and runs self-test. When the DECserver 90L is in
authorized mode the port you are using must be in manager mode to reset
another port or the server.
For ports that have not had their speed set using the set command they
will be in the non-autobaud state (no speed set). After being reset, the
Return
key must be pressed twice to autobaud the port and set the speed.
Reset Command by Menu
The following example shows the reset command used to reset port 1. The
examples show the command entered interactively.
1.
Enter Reset at the DECserver 90L prompt. The * indicates the port
you are attached to.
2.
Enter 1.
->
RESET
Return
|1 PORT_1*
|2 PORT_2
|3 PORT_3
|4 PORT_4
|5 PORT_5
|6 PORT_6
|7 PORT_7
|8 PORT_8
|S Server
|
| 1
Return
-> %DS90L-110, Port Has Been Reset
->
Reset Command by Command Line
The command line equivalent is:
->
RESET 3
Return
-> %DS90L-110, Port Has Been Reset
->