Managing the DECserver 90L
4–3
Management Commands
The commands used to manage the DECserver 90L are the Set, Show
and Reset commands. The set and show commands use a menu to select
the parameters to show or set. A command line mode is available for use
by network management software or by users that want to bypass the
menu interface. Refer to the Command Line section at the end of this
chapter, for more detailed information on command line mode.
The following sections show how to enter the Set, Show, and Reset
commands using the menu and the command line.
Set Command
The Set command allows you to set port or server parameters, zero
network counters, and enable and use the DECserver 90L security
features.
Setting Port Parameters
The following port parameters can be set for each port:
•
Port name
•
Port speed (baud rate)
•
Input flow control
•
Output flow control
•
Device type (terminal or printer)
•
Local or remote break
•
Remote modify
•
Test (loopback) operation
Table 4–1 describes each of the port parameters that can be set.
Port parameters can be set from the menu or by a command line entered
at the prompt. If authorized mode is set and the port parameters to be
set are for a port other than the one you are connected to, you must first
enable manager mode.
