Figure 53. Installing the internal MicroSD card
Next steps
Follow the procedure listed in
After working inside your system
IDSDM
Removing the optional internal dual SD module
Prerequisites
1. Follow the safety guidelines listed in
on page 45.
2. Follow the procedure listed in
Before working inside your system
3.
NOTE:
The procedure to remove IDSDM and the BOSS M.2 card is the same.
Steps
1. Using the Phillips #2 screwdriver, loosen the retention screw that connects the internal dual SD module (IDSDM) to the system board.
2. Lift the release tab that secures the IDSDM to the system board.
3. Holding both ends of the IDSDM, lift the IDSDM out of the IDSDM/BOSS M.2 connector on the system board.
Installing and removing system components
89
