Figure 37. Installing the M.2 SSD module
a. module connector (2)
b. screws (2)
c. modules (2)
Next steps
1.
NOTE:
Installing the BOSS card is similar to installing the expansion card riser.
2.
.
3. Follow the procedure listed in
After working inside your system
Network Daughter Card
Removing the Network Daughter Card
Prerequisites
1. Follow the safety guidelines listed in
on page 45.
2. Follow the procedure listed in
Before working inside your system
3.
Remove the PCIe mezzanine card
Steps
1. Using the Phillips #2 screwdriver, remove the two screws that secure the Network Daughter Card (NDC) to the system board.
CAUTION:
To prevent damage to the NDC, you must hold the card only by its edges.
2. Lift the card from the system board.
Installing and removing system components
75
