Dell E02B005, Инструкция по установке и обслуживанию

Страница: 90 / 106

Figure 54. Removing the optional IDSDM module
Next steps
Install the IDSDM .
Installing the optional internal dual SD module
Prerequisites
Follow the safety guidelines listed in Safety instructions on page 45.
NOTE: You must install either the Internal dual SD module (IDSDM) or the BOSS M.2 card in the same IDSDM/BOSS
M.2 connector.
NOTE: The procedure to install IDSDM and the BOSS M.2 card is the same.
Steps
1. Holding both ends of the IDSDM, insert the IDSDM into the IDSDM/BOSS M.2 connector on the system board.
NOTE: For information on the location of the IDSDM/BOSS M.2 connector, see the System board jumpers and
connectors section.
2. Push the release tab that secures the IDSDM to the system board, in place.
3. Using the Phillips #2 screwdriver, tighten the retention screw that connects the internal dual SD module (IDSDM) to the system
board.
90 Installing and removing system components