Figure 49. Installing the system battery
Next steps
1. Install the following:
a.
b.
2. Follow the procedure listed in
After working inside your system
3. Enter the System Setup to confirm that the battery is operating properly.
4. Enter the correct time and date in the System Setup's
Time
and
Date
fields.
5. Exit the System Setup.
6. To test the newly installed battery, remove the system from the enclosure, for at least an hour.
7. Reinstall the system into the enclosure, after an hour.
8. Enter the System Setup and if the time and date are still incorrect, see the
section.
Replacing the NVRAM backup battery - Option B
Prerequisites
NOTE:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same
or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's
instructions. See the safety instructions that came with your system for additional information.
1. Follow the safety guidelines listed in
on page 45.
2. Follow the procedure listed in
Before working inside your system
3. Remove the following:
a.
b.
Steps
1. Locate the system battery on the system.
2. To remove the battery:
Installing and removing system components
85
