Figure 46. Installing the RAID controller battery
3. Align the drive cable connector and the storage controller card, and using the Phillips #2 screwdriver, tighten the retention screws on
the drive backplane cable connector to secure the card to the system board.
Figure 47. Installing the drive cable connector
Next steps
1. Install the following:
a.
b.
c.
2. Follow the procedure listed in
After working inside your system
System battery
Replacing the NVRAM backup battery - Option A
Prerequisites
NOTE:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same
or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's
instructions. See the safety instructions that came with your system for additional information.
1. Follow the safety guidelines listed in
on page 45.
2. Follow the procedure listed in
Before working inside your system
3. Remove the following:
Installing and removing system components
83
