DATREND Systems AMPS-1, Руководство по эксплуатации

Страница: 77 / 100

AMPS-1 OPERATING MANUAL
AUTO1 =<
NORMAL ADULT
Figure 66 - Auto selection, ALPHA mode
12 Automated Settings
12.1 Overview
The Automated Settings of AMPS-1 provide ten patient simulation setups which are
user-programmable. These setups allow multiple simulation parameters to be
simultaneously modified in as little as two keystrokes, without affecting the power-on
default settings of the simulator.
The Auto setups are created or modified using the AMPSpc software, as described in
Section 13.4 of this manual.
12.2 Choosing an Auto Setting
With AMPS-1 in the ALPHA operating mode (the default mode after powering up),
press the AUTO (0) button.
Pressing the LEFT (
t
) or RIGHT (
u
) arrow buttons will scroll the display through the
Auto setups AUTO1 to AUTO10, as indicated in Figure 65 .
When the desired Auto setup is displayed, press ENTER to activate the parameters of
that Auto.
Auto setups can also be selected when operating AMPS-1 in NUMERIC mode. Press
SHIFT to toggle AMPS-1 from ALPHA to NUMERIC mode, then enter the three
digits corresponding to the desired Auto setting as listed below, then press ENTER to
activate the indicated Auto setup.
Automated Settings/Chapter 12
#
Page 63